Solar powered sonic ultrasonic cat repellent Defenders

STV-601 solar powered motion sensor cat alarm. Maximum area protected by the device: ~60m2. Motion detection 110° and max: 8m from the device.
The device is activated if there is movement in the field of view of the device in the area to be protected (attention! movement of branches does not activate the device!)
The alarm is a burst of continuously varying ultrasonic frequency between ~18kHz-27kHz. An activation time is approximately 30sec. The device is weatherproof. It is recommended to place away from irrigation systems.

Commissioning:
Remove all packaging around the unit and follow the instructions for use. Using a screwdriver, unscrew the cover of the waterproof battery compartment and insert the 3pcs AA rechargeable batteries (included!). Pay attention to correct polarisation! Screw the battery compartment cover back on. Leave the device in the "off" position in a sunny area for 2 days. Alternatively, you can charge the device with a USB cable (included!). In this case, 8 hours of continuous charging will bring the device to its maximum charged state.
Switch on the device using the black push button on the front panel. The red LED behind the device's motion sensor will flash for a moment, indicating that the device is ready to use and switched on. Move your hand in front of the motion sensor to make sure it is working. In this case, the LED will flash red and remain lit for the duration of the alarm (approx. 30 sec). If there is no movement in front of the device, it will monitor the area in a standby mode. Use the device outdoors only!

Installation. Allow time for the device to work against intruding pets.