Dicophar 0,1 l

Home use: 100ml of product mixed in 10l of water, applied with a sprayer. 10 litres of spray is sufficient for 100m2 of surface.

General information
Formulation: water soluble liquid concentrate (SL)
Active ingredients: 2,4-D 70 g/l MCPA 70 g/l MCPP-P 42 g/l dicamba 20 g/l
Effect The combination of the 4 active substances kills virtually all perennial and seed-bearing biennial weeds in lawns.

Application : The product should be applied at a rate of 10 l/ha (100 ml/100 m2) after mowing and after the resumption of biennial weed growth. The amount of water required for application is 10 l/100 m2 . Care must be taken to avoid spraying the spray on cultivated plants, as it will cause permanent damage to them. The product can be applied as a spot treatment and as a complete surface treatment. A maximum of two treatments per growing season may be applied. Minimum time between two treatments: 28 days Do not treat lawns less than 6 months old. Do not use Dicophar in persistently dry weather or if rainfall is expected within 6 hours of treatment. Do not treat the lawn immediately after mowing, wait a few days for the weeds to start growing again. Also wait a few days (5 days) after treatment before mowing again. Do not use in meadows, fields or pastures because of the clover control effect! Prohibition: do not use in pastures, the mown crop is not suitable for feeding. Health withdrawal period: no prescription required for normal use.

Dicophar Biparticulate Weedkiller for Turf

Highly effective herbicide spray for cultivated lawns. Highly effective herbicides for high yields.

Mode of action. When applied to the surface to be treated, it does not damage annual plants (such as grasses) but kills dicotyledonous plants. It penetrates through the green surface to the roots, killing unwanted weeds within a few days.

It can be used from the beginning of the bushing period (April) until September, during the frost-free period. It is recommended that you apply one week after mowing (at the start of dicotyledonous weed growth) - this is when it is most effective. Mowing is not recommended for a week after application. It is best to wait until the product reaches the roots of the weeds. The product can be used to treat the entire surface or to weed only patches. After application of Dicophar, do not allow the lawn to receive rainfall or water within 6 hours.

1. Estimate the size of the area to be treated
2.
3. Pour half of the water into the spray tank.
4.
5. Pour the measured amount into the spray tank
6. Rinse the measured container to make use of the remaining chemical.
7. Pour the rinse water into the sprayer
8. Pour the remaining water into the sprayer
9. Spray the surface
10. after spraying, rinse the sprayer three times and spray the wash water on the area already treated.

Be careful not to drift the spray onto other crops as it may cause permanent damage to them. For use on newly planted lawns after 6 months. Do not use during periods of drought, heat or when the grass is stressed (burnt out, weakened). The product should be used no more than 2 times per growing season (April to September). Wait at least 28 days between two treatments! Do not use on pastures, sprayed and mown plants are not suitable for feeding! Do not use in meadows or pastures because of its clover repellent effect!